COMPONENTS Show
 REMOVAL 1. DRAIN ENGINE COOLANT 2. REMOVE DRIVE BELT (See REMOVAL ) 3. REMOVE NO. 3 TIMING BELT COVER LH (See REMOVAL ) 4. REMOVE CAMSHAFT POSITION SENSOR Remove the bolt, stud bolt and camshaft position sensor. INSTALLATION 1. INSTALL CAMSHAFT POSITION SENSOR Install the camshaft position sensor with the bolt and stud bolt Torque: 7.5 N*m (80 kgf*cm, 66 in.*lbf) 2. INSTALL NO. 3 TIMING BELT COVER LH (See INSTALLATION ) 3. INSTALL DRIVE BELT 2006 ENGINE PERFORMANCE Engine Control System - Sequoia (See INSTALLATION ) 4. FILL ENGINE COOLANT (See REPLACEMENT ) 5. CHECK ENGINE COOLANT FOR LEAKS 6. CHECK IGNITION TIMING (See ON-VEHICLE INSPECTION ) 2006 ELECTRICAL Charging - Sequoia 2006 ELECTRICAL Charging - Sequoia Continue reading here: Charging System Was this article helpful?
Asked by jvalencia May 19, 2017 at 10:50 AM about the 2000 Toyota Tundra V8 SR5 2 Door LB 4WD Question type: Maintenance & Repair where is the cam sensor located 4 AnswersIf the timing belt was just done or is overdue, you may have belt issues. The cam sensor is under the timing cover by the cam. Remove upper plastic timing cover and you will see it. If you wanna test it, minimum resistance is 835 ohms and maximum is 1400 ohms and you measure it with engine cold. 10 people found this helpful.
what is the procedures to test the camshaft position sensor. have replaced sensor and pu is still having problems. is there something else i need to check 8 people found this helpful.
camshaft position sensor issue is on a 2001 toyota Tundra 4.7 7 people found this helpful. just found out today check engine light wouldnt go out with computers for inspection on a 2007 toyota tundra that had cam shaft sensor and crankshaft sensor replaced also couldn't get check engine light off found out today their is 2 camshaft sensors on my 2007 toyota tundra. my suggestion is find out how many sensors you have and replace mine went all at once. Your Answer:Related Questions
Looking for a Used Tundra in your area?CarGurus has 17,195 nationwide Tundra listings starting at $3,000. Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies. What are the symptoms of a faulty camshaft sensor?A glowing check engine light, stalling, poor acceleration and bad fuel mileage are all possible signs your camshaft position sensor may be failing. Gone are the days of carburetors and distributors, replaced by a variety of sensors that help a car's computer get the maximum performance out of the engine.
Which side is the bank 1 camshaft position sensor?Bank 1 is the side of your engine that has the cylinder 1, while sensor B refers to the exhaust camshaft side.
Where is my Cam position sensor located?The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.
|
2006 toyota tundra 4.7 camshaft position sensor location
Related Posts
Copyright © 2024 membukakan Inc.
