Unique Features and Specifications Ultrasonic Tech nology This humidifier uses ultrasonic high frequency tech nology to convert the water into 1–5 million super particles that are dispersed into the air evenly. LED Digital Readout Displays current room humidity, programmed humidity setting, timer setting, warm or cool mist selection and mist output level. Programmable Humidistat Customize the level of humidity between 35% – 65% in 5% increments. Built-In Timer Programmable timer, up to 12 hours. Night Light / Display Lights A useful light feature is included for your convenience. Auto Shut-Off Protection When the tanks are empty the unit will shut off automatically. Capacity 2.0 gallon – 7.57 liters Dual Water Tanks Refill one tank while the other is running. Run Time: 120 hours Run time is calculated based on using cool mist and setting the mist level to low setting. Based on the natural humidity level in your home, the temperature of water you use, and the mist level setting you choose, you may experience longer or shorter run times. 4 Document Distributed by Cool & Warm Mist Ultrasonic Humidifier UHE-WM68 IMPORTANT SAFETY INSTRUCTIONS:WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT,BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:READ ALL INSTRUCTIONS BEFORE USING
SAVE THESE INSTRUCTIONSCAUTION – PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATION.
Attention California Residents: Unique Features and SpecificationsUltrasonic Technology Control PanelHow To UsePower ON/OFF Button Mist Temperature Setting Programmable Humidistat Timer Press the TIMER button. Keep pressing the TIMER button until the desired timer setting is lit on the display. The timer button will cycle through the following settings 0 hours, 2 hours, 4 hours, 8 hours, 12 hours, 18 hours, 24 hours, 0 hours. To turn the timer OFF, press the TIMER button until 0 hours is shown on the display. NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting. How to FillCAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet.
About White Dust:Use of high mineral content hard water may cause a white mineral residue to accumulate on surfaces in the room near the humidifier. The mineral residue is commonly called “white dust.” The higher the mineral content (or, the harder your water is), the greater the potential for white dust. The white dust is not caused by a defect in the humidifier. It
is caused only by minerals suspended in the water. Installation Instructions
Demineralization Cartridge Cleaning and CareCAUTION: Before cleaning the unit, turn power off and unplug unit from the outlet. To Clean the Tank TroubleshootingFCC DISCLAIMERNOTE: This product has been tested and complies with the requirements for Federal Communication Commission, Part 18. Although this product is tested and complies with FCC, it may interfere with other devices. If this product is found to interfere with another device, separate the other device and this product. Conduct only the user maintenance found in this instruction manual. Other maintenance and servicing may cause harmful interference and can void the required FCC compliance. LIMITED ONE YEAR
WARRANTY For service in the USA: email: [email protected] Homedics UHE-WM68 Cool and Warm Mist Ultrasonic Humidifier Instruction Manual and Warranty Information –
Download [optimized] How do I reset my HoMedics ultrasonic humidifier?Place the tank on the humidifier, refill the tank, turn on the humidifier, and press and hold the clean transducer reset button until the "CLEAN" light turns off.
How do you use HoMedics cool mist humidifier?Fill the tank with clean, cool water. We recommend using distilled water if you have hard tap water. Replace the cap and install the tank back onto the base. Turn your power knob to your preferred misting setting.
|