How to make a big rubber band bracelet

To make a rubber band bracelet with your fingers, first place an orange band around your middle finger. Then, twist it into a figure 8 and place 1 of the loops on your ring finger. Wrap 2 purple bands around your ring and middle fingers, above the orange band. Now, pull the loops of the orange band over your fingers so they rest in the middle of the purple bands. Wrap another purple band around your 2 fingers. Then, take the bottom-most purple band over the top of your fingers so it rests in the middle with the orange band. Continue this process until your bracelet is the length you want. Just make sure you have 3 elastics around your fingers at any given time! To learn how to create a rubber band bracelet with a loom, read on!

Did this summary help you?YesNo

Thanks to all authors for creating a page that has been read 59,805 times.

The Patent Public Search tool is a new web-based patent search application that will replace internal legacy search tools PubEast and PubWest and external legacy search tools PatFT and AppFT. Patent Public Search has two user selectable modern interfaces that provide enhanced access to prior art. The new, powerful, and flexible capabilities of the application will improve the overall patent searching process.

Move it up: Since blood increases further up your arm, wear your tracker higher on your wrist to improve the heart rate signal during workouts. Start by moving the device up to three finger widths above your wrist bone, then experiment with slightly lower placement. Keep it secure: The less your tracker moves during exercise, the more chance you have of maintaining a heart rate signal throughout the activity. Do not wear the band too tightly, as this can restrict blood flow and goes against our wear and care guidelines. Hold steady for ten seconds: High intensity exercises or activities that cause you to keep your wrist bent (like push-ups) or move your arms vigorously (like dance) may interfere with heart rate signals. If you stop seeing a signal during these types of activities, hold your wrist steady for ten seconds during breaks to get your reading.

Manufacturer Contact Information

Customers contact: [email protected]

To make a beaded bracelet, start by cutting a piece of elastic that's 1.5 times longer than your wrist. Next, fold a piece of tape over the end of the elastic to prevent the beads from falling off. Once it’s secure, add beads until there are enough beads to wrap around your wrist. When you’re done adding beads, take off the tape and tie a square knot with the the ends of the elastic. For tips on adding a clasp to your beaded bracelet, read on!

Did this summary help you?YesNo

Thanks to all authors for creating a page that has been read 555,855 times.

What is the largest rubber band bracelet?