Auto Start-Stop is ‘designed’ to save us some gas money, it might save us a few dollars per year, but that’s actually not the goal of the manufacturer. This guide will show you how to disable this annoying feature on Jeep Cherokee, Grand Cherokee and Wrangler & Compass. Show
 The primary purpose of Auto Start-Stop feature is to reduce fleet emissions for the auto manufacturer, not save you gas money. This is why they have devoid us of an option of permanently disabling this function. Fortunately, there is a workaround to this, and does not cost any money, its just a matter of unplugging a wire.
After removing the sensor, you will see an alert “Start/Stop Unavailable, Service Start/Stop” in your instrument cluster screen every time you start your vehicle – but it goes away by itself after a few seconds. The IBS sensor is located on the main 12V battery under the hood. Remove the plug from the sensor on the negative pole. Jeep WranglerThe method is a little different in Wrangler, pull up the button type sensor that detects closing of the hood and unplug the wire beneath it. Don’t worry, it won’t show you hood open warning in dash, as the button sensor on the left is for that purpose. The one on the right is only linked to Auto Start-Stop. What is Intelligent battery sensor (IBS) for?The IBS continuously analyzes the status of conventional 12-volt lead-acid batteries and provides information on parameters such as state of charge (SOC), starting ability (SOF) and aging (SOH) of the battery. The sensor is essential for the reliable operation of vehicle start-stop systems. It can be used on any standard battery. In addition to monitoring the battery, the IBS also helps in the detection of defective electronic vehicle components, since it also monitors the quiescent current. The sensor improves the diagnostic capability of the car and enables warnings of possible breakdowns, even if they are not caused by the battery. With an improved charging strategy, the IBS also extends the battery life by 10 to 20 percent. Are you
wondering how the Stop/Start feature in the 2020 Jeep Wrangler works? This system shuts off the Wrangler after it comes to a stop for a few seconds for fuel efficiency purposes. Check out the video below to learn about the Stop/Start function in the 2020 Jeep Wrangler. Related Content: Approach and Departure Angles for the 2020 Jeep Wrangler Get a 2020 Jeep Wrangler in Duncanville, TXAre you interested in getting a new 2020 Jeep Wrangler near Duncanville, TX? Check out our new Jeep inventory at Freedom Chrysler Dodge Jeep Ram by Ed Morse! Related PostsWhy does my Jeep stall when I stop?There are three major causes for a stalled engine: A lack of fuel, a lack of air flow and improper ignition. Running out of fuel is one of the most common causes of engine stalling, but dirty fuel injectors or a plugged fuel filter can also be the culprit. Your engine needs air to run properly as well.
What causes a Jeep Wrangler to shut off while driving?When the battery is weak, it has very low cranking power and amps. This can cause incorrect electrical signals, “confusing” the ECU, causing your Jeep to stall unexpectedly. A weak battery also means extra hard work for your alternator to try and charge the battery and keep the engine running.
Why would my car shut off while idling?What Causes a Car Engine to Stall While Idling? A car can stall while idling due to a defective oxygen or mass airflow sensor. It can also be caused by an EGR valve that's stuck open or fouled spark plugs. Additionally, the idle air control valve, throttle body, fuel system or transmission could be to blame.
|
Why does my jeep turn off when i stop
Related Posts
Copyright © 2024 membukakan Inc.
